Details of the method of window glass film

First, the glass surface must be clean and free of dust, which can be wiped with a cotton cloth. Then start to stick the Glass Surface Protection Film, fix side 1 first, use a relatively hard plastic board "the edge of the board should be very straight" and push it from 1 to the other side. After the whole surface is attached, use a cotton cloth to wipe the position of the air bubbles in one direction. If you cannot wipe it back and forth, it will not be able to remove the air bubbles well.

Spray water on the glass, and it doesn't matter if it flows down. After sticking it, the air bubbles at the bottom are easily scraped out with a scraper, and it will dry after a while. Just stick it down and let the air go, just remember to keep the water in the glass and stick it! Don’t be quick, fix the local corners first, use a semi-dry rag to move slowly, and when there are slight air bubbles, you can stick a small point with a needle tip Hole, it's OK to get rid of the air bubbles.

Steps for window glass film:

1. Clean the glass, wash the glass so that there is no dander, dust and sand on the glass.

2. Cut the film Cut the film according to the glass size.

3. After cleaning the glass, spray a layer of water on the glass

4. Spray a layer of water on the film and the protective film at the same time to separate the protective film and the film.

5. Scrape off the water between the film and the glass, slowly scrape out the water inside with a film scraper, and trim off the excess film at the corners.

Window Film Tips:

1. When cutting the film, the film should be slightly larger than the glass by more than 1cm.

2. The film is divided into two layers, the layer is a colorless transparent protective film, and the layer is a color film.

3. When sticking the protective film up and down, scrape the water in the direction of 4 points, so that the film has no air bubbles.

Note on window film:

1. Whether the wiper blade is flat and smooth, and whether there is a gap, be sure to check the tool carefully.

2. Check the size and quantity of the protect film for glass.

3. When measuring the size of the window, it must start from the same side of the window. When cutting, align the edge of the film with the center line and cut.

4. When all window films are applied, spray a small amount of cleaner to remove other residues. Wipe with a dry rag to keep the windows smooth and bright.

Summary: After the film is removed from the adhesive, it can be directly attached to the glass, but it is easy to wrinkle, but if there are wrinkles, it is difficult to remove. You can pour water on the glass first (the glass is best placed horizontally), it is better to add some detergent to the water, and then apply the film, because of the lubrication of the water, it is very easy to paste and can be adjusted.

While sticking, use a ruler to level it, and most of the water is also driven out, very simple.

As for the residual moisture between the glass and the film, there is no need to worry, it will disappear soon. It will be very firm in the future.